Slicer Discord
Lamp  – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Lamp

von JH · Decor
10.4k Downloads
4k Likes
4.8k Makes
Zum Modell
Designer-Esque fully 3D-printable Vasemode Lamp DesignThe Lampshade and the base thread into each other for a seamless and sturdy appearance. Although it is designed to fit the Bambu Labs “LED Lamp Kit” you can easily modify the Base to fit any light source (details see below).Printing Instructions (settings already implemented in .3mf files)Lampshade:The first 6mm of the Lampshade is the part that screws into the base and therefore is designed to be printed solid (achieved by enabling solid bottom layers). From there on upwards is the actual Lampshade that is ideally printed with Vasemode. For these settings proceed as followed:Select preferred layer height (0.2mm recommended - as seen in pictures)Enable Vase ModeSet solid bottom layers for the first 6mm.0.10mm layer height = 60 solid bottom layers (59 if first layer is still 0.2mm)0.15mm layer height = 40 solid bottom layers0.20mm layer height = 30 solid bottom layers0.24mm layer height = 25 solid bottom layers0.30mm layer height = 2
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Fortgeschritten Mittlere Konfidenz
Warum?
großer Druck · 0.10mm Schichten
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 2/3
Druckbett 2/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
ABS
Mindest-Druckbett
200 mm (Groß)
Schichthöhe
0.1 mm
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen