Thingiverse
Lamp Shade 089
von _Steve
45
Downloads
32
Likes
0
Makes
There are a lot of great lamp shades out there to print, thought I'd give it a try. It's just a small difference from the flower and pencil vases I do.
This is a twisty, crisscross table lamp shade to give soft light on a desk or in the corner of your room. There are no wires to cut, splice or solder together to make a base. It is designed to fit on a 4 inch/10cm led display base. The printed shade sits on top of the base, it is not attached. I used a colored led base from Amazon here:
https://www.amazon.com/dp/B08YYTGX2H?psc=1&ref=ppx_yo2ov_dt_b_product_details
Or a white one here:
https://www.amazon.com/dp/B08Y5GCPTC?ref=ppx_yo2ov_dt_b_product_details&th=1
The lamp shade should be printed without a top or a bottom. The stl file is solid with a top and bottom so be sure and put 0 bottom layers and 0 top layers in your slicer.
The vase in the photos is printed in vase mode and has not been scaled and is printed at 100% of the stl file. The x and y axis shows 116mm wi
This is a twisty, crisscross table lamp shade to give soft light on a desk or in the corner of your room. There are no wires to cut, splice or solder together to make a base. It is designed to fit on a 4 inch/10cm led display base. The printed shade sits on top of the base, it is not attached. I used a colored led base from Amazon here:
https://www.amazon.com/dp/B08YYTGX2H?psc=1&ref=ppx_yo2ov_dt_b_product_details
Or a white one here:
https://www.amazon.com/dp/B08Y5GCPTC?ref=ppx_yo2ov_dt_b_product_details&th=1
The lamp shade should be printed without a top or a bottom. The stl file is solid with a top and bottom so be sure and put 0 bottom layers and 0 top layers in your slicer.
The vase in the photos is printed in vase mode and has not been scaled and is printed at 100% of the stl file. The x and y axis shows 116mm wi
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
