Landing Gear

This is a landing gear for a simple rc glider with a rod-fuselage with a diameter of 3/16 inches. For the wheels you will need a 120x2 mm metal axle for the front/bigger landing gear and a 20x2 axle for the back/smaller landing gear. Assembly , for the front landing gear, slide corresponding axle into the shaft at the bottom and slide two wheels into the side. You may need to superglue the wheels to the axle. Also for the top of the print is the front of the landing gear. For the back landing gear, put the remaining wheel in between both shafts and slide in the remaining/corresponding axle, once again superglue may be needed. Installation: for the front, slide in the big tube thing into the the front of the rod and glue it, and for the back; I designed it so it would not interfere with the tail fins so just put it under at the back of the rod and glue it on.