Thingiverse
Lantern, Pencil Holder, candle holder - stackable
von Entilein
6
Downloads
8
Likes
0
Makes
A nice little candle holder (electrical candles when you print with PLA!).
You can also use it as a holder for pencils or other little stuff or as a vasr.
I designed it in two variants and a lid that it is stackable.
Added a lid where the upper holder sits tight, but this one need support.
The "double sided Lid with no support" must print in the position it was saved.
The big ones on the picture are 70% the little transparent one is 50%.
No support needed - print in Vase mode (spiralize).
You can also use it as a holder for pencils or other little stuff or as a vasr.
I designed it in two variants and a lid that it is stackable.
Added a lid where the upper holder sits tight, but this one need support.
The "double sided Lid with no support" must print in the position it was saved.
The big ones on the picture are 70% the little transparent one is 50%.
No support needed - print in Vase mode (spiralize).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
