Lanyard Innovation Tab
von DanMan10000
3
Downloads
0
Likes
0
Makes
This is a lanyard tab to show you are part of a community. The initial design was for Innovation. It should fit a normal lanyard.
The design is in 2 parts. For single extruder machines it is easier to just print them both together back to back. If you have multiple extruders then you can change the color of the rear half so that it shows through.
The design is in 2 parts. For single extruder machines it is easier to just print them both together back to back. If you have multiple extruders then you can change the color of the rear half so that it shows through.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!