Laptop Adjustable Stand

Adjustable stand with 2 options for short back distance or long, as well as wider or shorter width. Locks and unlocks easilly, and is packed for travelling.

8 possible back position / height and 2 positions for width (wide and short).
Works well on Laptops up 14 to 19 inch, tablets, books.

Designed to fit all together (2 bases, 2 supports, 2 short legs, 2 long legs) in a single bed 220X220 ready to print.
No need for any other non printable parts.

Tip:
Print the items on their side for no need for support, print diagonal to the bed if your bed is 220mm or less. (see screenshot attached)
At 120mm/s speed (130% for the infil), 20% infili and .4 layer size it it prints in about 5 hours all together.
Use .4 nozzle and .4 layer size for best results, better resolution may work but it may have slack on the gears. Let me know if it worked at smaller layer sizes.
I have tested this with PLA+ only, but I assume any material would do fine too.