Thingiverse
laptop camera cover
door mikesquires
8
Downloads
7
Likes
0
Makes
Laptop Webcam cover. Window is approx 40mm wide and 12.5 mm high. base should be glued onto laptop (I've also used double sided scotch tape.)
Gate piece will snap in and the geared handle allows you to swing it open. Takes about 20min to print at .1mm layer height on my Tevo Tarantula.
Good Luck! Hope this help you.
Gate piece will snap in and the geared handle allows you to swing it open. Takes about 20min to print at .1mm layer height on my Tevo Tarantula.
Good Luck! Hope this help you.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
