Laptop camera cover

Laptop camera security cover.

Included are a left and right fitting piece so you can see your camera light should it be turned on while you have the cover closed.

once printed and trimmed, you will see a hole in the side where the slider slips in. Push until the fingernail bump is visible in the hole for the camera.

Designed in Fusion360 personal use, sliced with Cura, tree support for the camera hole.

Make sure the sliding cover is set on the print bed with the fingernail opener facing up or it may not print properly.

The covers were printed on end with the hole down so not as much support was needed. Test prints showed it printed properly the other way around too.

PLA
bed temp 70
nozzle temp 195
layer height .2