MakerWorld
Office
Go to Model
Laptop Stand (14'' models)
46
Downloads
9
Likes
7
Makes
Stand for 14'' laptops such as lenovo IdeaFlex.The angle of the stand is 20 degrees.To assemble the stand you will also need 4X 16mm M3 screws.At the bottom of each bracket there are 3 slots in which you can glue 10mm rubber feet. I advice you to do so because most 3d printed plastics are quite slippery on most surfaces.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
