Laptop stand flexure with automatic adjustment

Just another vertical laptop stand...but this one has a flexible hinge at the bottom that adjusts to the thickness of your laptop.Nothing screams "I'm a maker" louder than this simple piece of 3D printed plastic.The thin layer in the middle of the bottom acts a a living hinge. As the laptop's weight pushes down, the gap at the top closes until the laptop is securely clamped.I designed this stand for an HP Z-Book Fury 15", which is about 20mm thick at this clamping height. If your laptop/notebook is very thin, you could scale the model in the Slicer. Just make sure you uncheck "Uniform scaling" (Cura). Then you can flatten it a bit.The stand is printed in one piece - no assembly required. It must be printed in an upright position, as there is a flat surface which provides good bed adhesion. The downside is that there are sharp edges, which can be rounded off with a little sanding.I printed the stand in CF-PETG which is very stiff but gives a nice matte finish