Thingiverse
Laptop Stand
von KonosV
2.4k
Downloads
2.3k
Likes
6
Makes
Stand for 14'' laptops such as lenovo ideaflex.
The angle of the stand is 20 degrees.
To assemble the stand you will also need 4X 16mm M3 screws.
At the bottom of each bracket there are 3 slots in which you can glue 10mm rubber feet. I advice you to do so because most 3d printed plastics are quite sllipery on most surfaces.
The angle of the stand is 20 degrees.
To assemble the stand you will also need 4X 16mm M3 screws.
At the bottom of each bracket there are 3 slots in which you can glue 10mm rubber feet. I advice you to do so because most 3d printed plastics are quite sllipery on most surfaces.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
