Thingiverse
Laptop stand
von araspitfire
100
Downloads
93
Likes
0
Makes
This Thing is for mounting a 14" sized laptop for use with external monitor and keyboard.. it allows the laptop to take up less space on the desk.
This thing is large... almost 200mm long on the angle. It will warp slightly when it cools, but the rods pull it straight again...
If you print in PLA then make sure the laptop doesn't melt it.
This thing is large... almost 200mm long on the angle. It will warp slightly when it cools, but the rods pull it straight again...
If you print in PLA then make sure the laptop doesn't melt it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
