Laptop Stands

Once again I went searching for something to print for my son. I really didn't like the options I saw since most of them are just hinges or straight up fancified logs of plastic. I wanted something that was easy to allow room for stuff underneath so I made these.There are a 300mm back stand and 200mm back stand, which was to make it so you can use it for lengthy or short depth laptops. Just be careful in the set up. The two front posts should go under the front corners of the laptop as their front lips are meanth to catch and hold the laptop from moving too much. My son uses three 200mm evenly spaced out, but you can use just two if you want to save on filament. Personally, I think it's better to use a board like those 3mm craft boards and place the board on that. The divots on top are for those who want to poor rubber in them to increase better grip.