Large Multisensor Enclosure

Multisensor enclosure inspired by BRUH. Wanted something a little bigger to allow plenty of room for wiring and possibly adding other sensors.

I put a small dab of hot glue on the nodemcu standoffs to keep it in place. Screws were just too much of a pain. I opted to mount the nodemcu on the side for (I think) easier cable management.

DHT22 mount/cover remixed from http://www.thingiverse.com/thing:480481

DHT22 can be screwed down but the fit is pretty snug and will snap in.

Lid is also just pressure fit. Small slot in the back to pry open.