Thingiverse
Larp_arrow_flat_8mm
by Meleniel
1
Downloads
1
Likes
0
Makes
This LARP arrow head is meant to be mounted on an arrow shaft of 8mm diameter. (Don't forget to remove the tip of the arrow!)
It also has to be padded with firm and soft foam, and it is best if the foam cylinder covers the flat part sides as well.
Added a ridge to allow to secure a cloth on top of the padded tip for identification and wear protection.
The objects are still separate for modification as needed.
Prepared in Bambu Studio, Basic PLA.
Enjoy and play responsibly,
Sincerely,
Meleniel
It also has to be padded with firm and soft foam, and it is best if the foam cylinder covers the flat part sides as well.
Added a ridge to allow to secure a cloth on top of the padded tip for identification and wear protection.
The objects are still separate for modification as needed.
Prepared in Bambu Studio, Basic PLA.
Enjoy and play responsibly,
Sincerely,
Meleniel
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
