Thingiverse
Laser collimator roller
por DARREN1977
9
Descargas
5
Likes
0
Makes
Will require two prints
Clean up joining edges and use a small amount of super glue
ensure both bottom surfaces are flat
after installing bearings (standard skateboard bearings ) heat pots ends with a lighter and press in with your finger to keep bearing from falling off
Clean up joining edges and use a small amount of super glue
ensure both bottom surfaces are flat
after installing bearings (standard skateboard bearings ) heat pots ends with a lighter and press in with your finger to keep bearing from falling off
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!