Thingiverse
Laser cut christmas pine tree
por NOTsoNOISY
344
Descargas
281
Likes
1
Makes
Here is a little decorative 20cm Christmas pine tree all smiling, to lasercut and assemble yourself. This is a new creation in laser cutting by the Swiss numeric artist **NOTsoNOISY GUILLAUME REYMOND [www.notsonoisy.com](http://www.notsonoisy.com)**. All prototype cuts were made at **FABLAB-FRIBOURG**. We use to cut in a **360x215mm / 5mm plywood**, but you can use what you want.
*UPDATE: I added a new file with a lighter/simpler version (no writing, no smiles, no additional stars) The drawing enters on a A4 format 297x210mm*
**/!\ BEWARE Measure precisely the thickness of your wood.** You must adapt proportionally the size of the entier drawing to the thickness of your wood. You will have to stack 29 pieces high, so if the real thickness of your wood is 4.75mm or 5.1mm the center mast will be too long or too short. The rectangles/squares/cross holes must also have the thickness of the wood. Select the entire design and apply the following percentage: resize (%) = measuredThickn
*UPDATE: I added a new file with a lighter/simpler version (no writing, no smiles, no additional stars) The drawing enters on a A4 format 297x210mm*
**/!\ BEWARE Measure precisely the thickness of your wood.** You must adapt proportionally the size of the entier drawing to the thickness of your wood. You will have to stack 29 pieces high, so if the real thickness of your wood is 4.75mm or 5.1mm the center mast will be too long or too short. The rectangles/squares/cross holes must also have the thickness of the wood. Select the entire design and apply the following percentage: resize (%) = measuredThickn
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
