Thingiverse
Laser Enclosure
von Chmann68
10
Downloads
8
Likes
0
Makes
Enclosure for small laser engravers. This uses 3 of the sheets from Jtech (Link below)
You will need 8 of the side runners, 2 of the of the bottom runners, and one each of the rest.
I used hot glue on the parts so they would not come apart when moving
https://jtechphotonics.com/?product=445nm-laser-shielding
You will need 8 of the side runners, 2 of the of the bottom runners, and one each of the rest.
I used hot glue on the parts so they would not come apart when moving
https://jtechphotonics.com/?product=445nm-laser-shielding
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!