Thingiverse
Laser XY Scanner
von thingengineer
332
Downloads
315
Likes
0
Makes
Laser XY Scanner
====================
Low Cost DIY 3D Printed stepper motor Laser XY Scanner - Draw, Cut, Engrave, or Scan
Laser XY Scanner is an open source stepper motor based scanner.
The components used are low cost and very accessible. This type
of laser scanner is not extremely fast but it can still be used in a
variety of applications. Draw, cut and or point with laser X and Y control.
The circuit:
-------------
* Arduino Nano
* Monitors small lever switches for X and Y home detection (minimum travel)
* Controls ULN2003APG high−current darlington drivers
* Drives 28BYJ-48 5V Stepper Motors
* 12V TTL 1W/1.6W/2W/445nm/450nm Laser Diode LD Driver
* Drives 2W 445nm M140 Blue Laser Diode w/ AixiZ aluminum mount and heat sink for 12mm modules
The Arduino code can be found in the project repository.
GitHub Project: https://github.com/ThingEngineer/Laser-XY-Scanner
The Instructable:
https://www.instructables.com/id/Low-Cost-DIY-Step
====================
Low Cost DIY 3D Printed stepper motor Laser XY Scanner - Draw, Cut, Engrave, or Scan
Laser XY Scanner is an open source stepper motor based scanner.
The components used are low cost and very accessible. This type
of laser scanner is not extremely fast but it can still be used in a
variety of applications. Draw, cut and or point with laser X and Y control.
The circuit:
-------------
* Arduino Nano
* Monitors small lever switches for X and Y home detection (minimum travel)
* Controls ULN2003APG high−current darlington drivers
* Drives 28BYJ-48 5V Stepper Motors
* 12V TTL 1W/1.6W/2W/445nm/450nm Laser Diode LD Driver
* Drives 2W 445nm M140 Blue Laser Diode w/ AixiZ aluminum mount and heat sink for 12mm modules
The Arduino code can be found in the project repository.
GitHub Project: https://github.com/ThingEngineer/Laser-XY-Scanner
The Instructable:
https://www.instructables.com/id/Low-Cost-DIY-Step
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
