Thingiverse
LaserBeamTarget
par Takeaway3DTech
29
Téléchargements
20
Likes
0
Makes
Laser beam Target to fit a Universal M300 laser to align the laser beam.
The Laser I have is an old > 10 years used laser cutter The problem seen was push fit bearing holes were not straight so bearings did not fit vertical to the board surface see pic of single bearing.
I noticed that the Lense assembly had a secondary counter bore around the laser hole made a target to fit the counter bore to alow laser alignment using the red spot laser / Lid open mode.
Push fit bearings now sit parallel after laser adjustment using the target
The Laser I have is an old > 10 years used laser cutter The problem seen was push fit bearing holes were not straight so bearings did not fit vertical to the board surface see pic of single bearing.
I noticed that the Lense assembly had a secondary counter bore around the laser hole made a target to fit the counter bore to alow laser alignment using the red spot laser / Lid open mode.
Push fit bearings now sit parallel after laser adjustment using the target
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
