Thingiverse
Lasercut e-reader stand
by maxy
3
Downloads
2
Likes
0
Makes
An e-reader stand for sitting at a table.
Made from 4mm (3.6mm) poplar plywood. Cut on a lasersaur, painted after cutting.
Works for most e-readers (landscape and portrait). Works for some phones (portrait mode only). The feet can grab into a pencil to adjust the tilt slightly. The upper holes are just decorative. If you find a use for them, please drop a comment or publish make :-)
Made from 4mm (3.6mm) poplar plywood. Cut on a lasersaur, painted after cutting.
Works for most e-readers (landscape and portrait). Works for some phones (portrait mode only). The feet can grab into a pencil to adjust the tilt slightly. The upper holes are just decorative. If you find a use for them, please drop a comment or publish make :-)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!