Lasercut IPAD 2 stand

lasercut ipad2 stand

cut on a glowforge from 3.6 mm plywood (1/8 inch)

made to sit on the reception at my employer and do the registration of visitors


the hinge allows the teblet to be placed in different angles, and then locked with the "fork"

if needed you can take off the bolts in the hinge and turn it 90 degrees to swicth to landscape. (might be carefull about tipping the ipad out when you do, or secure it in some way)


additional components:
- 6* m2.5 10mm standoffs
- 6* m2.5 Bolts
- 6* m2.5 Nuts
- 2* M4 bolts ( i added some spacers to the design so you can use any length you have as long as it's less than 3cm)


make sure all the glue is dried and well cured before placing an ipad in the case ;)


i used an angled ipad charging cable [like this](https://www.startech.com/eu/Cables/30-pin-cables/) to make sure the cable was not sticking out the bottom