Thingiverse
LaserPecker 2 Cutting Plate Locks
door tedreid
15
Downloads
11
Likes
0
Makes
These locks fit on the cutting plate offered as an accessory for the LaserPecker 2.
They line up either flush with one of the cutting plate ribs, or a certain amount over.
0: flush against a rib
1: 1mm past a rib
2: 2mm past a rib
3: 3mm past a rib
By combining these to fit around whatever you are trying to engrave, you can ensure they are in the same position for batch pieces, and/or ensure they are square. (I square the cutting plate up with the base of the LaserPecker 2)
They line up either flush with one of the cutting plate ribs, or a certain amount over.
0: flush against a rib
1: 1mm past a rib
2: 2mm past a rib
3: 3mm past a rib
By combining these to fit around whatever you are trying to engrave, you can ensure they are in the same position for batch pieces, and/or ensure they are square. (I square the cutting plate up with the base of the LaserPecker 2)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
