Thingiverse
LaserTorch
by bringho
5
Downloads
1
Likes
0
Makes
Update : 2020-12-20 12:20
Added ChiTuBox project and printer file for LaserTorch V2+. Inludes interna sipports as well. Printing V2+ right now...
Update : 2020-12-19 20:55
!!! Added the file "LaserTorch V2+.stl" where the mounting hole has gone from 9.5mm to 9.25mm decreasing the offset for overcure. also I shrunk the inner diameter of the hose connector as it looks to fragile, the original piece has a 3mm opening, the new model has a 2.8mm opening.
Original post below:
The air assist tube on the 10W Endurance Laser was to long to use when changing to the G7 lens so I made this attachment that use the same tube as the original part.
Preferably printed on a DPL resin 3D printer.
The part is a bit fragile but there are no forces except airflow coming from the hose.
Probably usable on any laser as it fits on the lens holder.
Added ChiTuBox project and printer file for LaserTorch V2+. Inludes interna sipports as well. Printing V2+ right now...
Update : 2020-12-19 20:55
!!! Added the file "LaserTorch V2+.stl" where the mounting hole has gone from 9.5mm to 9.25mm decreasing the offset for overcure. also I shrunk the inner diameter of the hose connector as it looks to fragile, the original piece has a 3mm opening, the new model has a 2.8mm opening.
Original post below:
The air assist tube on the 10W Endurance Laser was to long to use when changing to the G7 lens so I made this attachment that use the same tube as the original part.
Preferably printed on a DPL resin 3D printer.
The part is a bit fragile but there are no forces except airflow coming from the hose.
Probably usable on any laser as it fits on the lens holder.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
