Thingiverse
Latch for Side Cutters
par p1mrx
58
Téléchargements
125
Likes
1
Makes
Whenever I leave side cutters on my desk, I'm afraid they'll go after my USB cables when I'm not looking. Not anymore!
With my Xuron 170-II cutters, I can close the latch with a flick of the wrist. It still functions on my noname cutters, but not as well. You can "Modify > Change Parameters" in Fusion 360 if the tolerance is off.
Printed in PLA with 100% infill, no supports.
2024-02-28: updated to v2, which is more compact and locks in the open position so you can actually use the cutters without the latch getting in the way.
2024-03-07: v3 makes the grabbers a bit thicker, because they were breaking too often.
With my Xuron 170-II cutters, I can close the latch with a flick of the wrist. It still functions on my noname cutters, but not as well. You can "Modify > Change Parameters" in Fusion 360 if the tolerance is off.
Printed in PLA with 100% infill, no supports.
2024-02-28: updated to v2, which is more compact and locks in the open position so you can actually use the cutters without the latch getting in the way.
2024-03-07: v3 makes the grabbers a bit thicker, because they were breaking too often.
p1mrx publie également sur
29 modèles supplémentaires sur 1 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
