Thingiverse
Latch Lock Remix
von Jaqen63
4
Downloads
4
Likes
0
Makes
The original one was too big for my needs.
Just print:
1x Base
1x Open
1x Close
1x Lath
Just fix the base with 1 screw, you can enlarge the diameter by piercing it.
At the other end, put the open, then latch, the close. You may need to sand down a bit the "open" part for fluide movement.
Each piece is very simple to print and requires no support.
Just print:
1x Base
1x Open
1x Close
1x Lath
Just fix the base with 1 screw, you can enlarge the diameter by piercing it.
At the other end, put the open, then latch, the close. You may need to sand down a bit the "open" part for fluide movement.
Each piece is very simple to print and requires no support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!