Latching broom holder

This is a remix from fallerd's great design, for a 21 mm diameter broomstick.

Initially, I just wanted be able to print it at a lower resolution (less time), but after redrawing it and adjusting the tolerances I decided to incorporate a couple of cosmetic changes.

After an initial working print at 0,3 mm, I ended up printing several at 0,1 mm for cosmetic reasons (used PLA).

Also added a center hole for fixing onto the wall, as I didn't want to make unnecessary perforations on the ceramic tiles covering it.

Three nails of approximately 1.65 mm in diameter I had at hand, worked perfectly for the hinges, and instead of hammering them into the print I used a drill to allow the friction generated heat to adjust the printed hole diameter. Just beware that you will need to be able to remove at least one of them in order to fix the broom holder onto the wall.

Finally, while V2 is the same height as the original (30 mm), I made v2s 24 mm tall in order to shorten print times (ima