Lathe-Chuck-Nut-Holder

Sorry about the photos, I only had BLACK which is extra hard to see.


Makes it easy to ON AND OFF the nuts that hold the chuck and other things bolted to the spindle.

For I think all China-made lathes with the standard chuck. 7 x (10 or 12 or 14) lathes.

The nuts will just flip on and off. Just be careful with the wrench while tightening so as not to bust off the small plastic nut tabs.

Make sure the plastic nut tabs on your printed part have NO burs or catches before you glue it on.

I used super glue....which may only last a while. Use contact glue if you have it, after degreasing all the oil around your two glue surfaces.

%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
Using..........

Just loosen the three nuts to finger tight. Now turn the chuck to align the "stud-nut" with the plastic tab. Know just use your finger to flip the nut off the chuck onto the plastic tab holder. Go to the other two nuts and do the same. That easy. Do reverse for installing the nuts on the chuck or