Thingiverse
Lathe Chuck Spider
door Ken226
23
Downloads
10
Likes
0
Makes
This is a lathe chuck work stop (spider), for chucking very short parts near the chuck jaw tips. It is designed for jaws that are 1" wide, and 1.75 deep. This one is 1.25 high, which allows 1/2" of jaw to engage the part. Print using PLA/ABS/PETG, no supports needed.
It has 3 slightly undersized holes in the bottom to allow you to epoxy/press in 12mm x 6mm neodymium magnets.
It has 3 slightly undersized holes in the bottom to allow you to epoxy/press in 12mm x 6mm neodymium magnets.
Ken226 publiceert ook op
243 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!