Thingiverse
Lathe Dial Indicator Clamp
von qfinucan
5
Downloads
3
Likes
0
Makes
Inspired by a Blondihacks concept. https://www.thingiverse.com/thing:2854617
Changes were made to fit the Lathe way geometry of my lathe (ELATHE250, aka AL-250G) and the screw direction changed due my lead screw cover restricting space below the clamp.
There are two Main bodies, only print one depending on your indicator stem diameter. Mine is 8mm but some Mitutoyo's have a 9mm stem.
The screw I used is a M6 46mm long with 10mm hex head, nut is also 10mm hex.
Designed in Onshape.
Changes were made to fit the Lathe way geometry of my lathe (ELATHE250, aka AL-250G) and the screw direction changed due my lead screw cover restricting space below the clamp.
There are two Main bodies, only print one depending on your indicator stem diameter. Mine is 8mm but some Mitutoyo's have a 9mm stem.
The screw I used is a M6 46mm long with 10mm hex head, nut is also 10mm hex.
Designed in Onshape.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
