Thingiverse
LaunchPad on a Flag Pin
by GiantRabbit
0
Downloads
0
Likes
0
Makes
For FPV racers. A launchpad to be put on a metal flag pin. The benefits are:
- Elevated height, no worries about stuff getting on your lens while taking off.
- Serious FPV flyers do probably have same spare track gear, like a metal flag pin.
- It's freaking sturdy.
Printed in ABS and also in PETG, no problems whatsoever. For strength, set walls to 6 layer thickness, 25% infill. No support required.
When done, slide the RailHoder and the PoleHolder into each other, they are stuck for live.
The RailEnd en RailMiddle you also need to print them mirrored.
My printing times were:
- RailHolder 3:40
- PoleHolder 1:58
- RailEnd 0:34
- RailMiddle 1:35
Depending on your filament/printer, you might need to take a 14mm drill and drill out the circular one (not the slot, that one should be big enough), because its a tight fit.
For the rails you need 2 aluminum extrusion profiles, available at your local hardware store.
- One L-Shaped 40x14x1.5 mm
- Elevated height, no worries about stuff getting on your lens while taking off.
- Serious FPV flyers do probably have same spare track gear, like a metal flag pin.
- It's freaking sturdy.
Printed in ABS and also in PETG, no problems whatsoever. For strength, set walls to 6 layer thickness, 25% infill. No support required.
When done, slide the RailHoder and the PoleHolder into each other, they are stuck for live.
The RailEnd en RailMiddle you also need to print them mirrored.
My printing times were:
- RailHolder 3:40
- PoleHolder 1:58
- RailEnd 0:34
- RailMiddle 1:35
Depending on your filament/printer, you might need to take a 14mm drill and drill out the circular one (not the slot, that one should be big enough), because its a tight fit.
For the rails you need 2 aluminum extrusion profiles, available at your local hardware store.
- One L-Shaped 40x14x1.5 mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
