Laundry basket handle

Finally got around to replacing the yellow handle on the laundry basket.

I revisited this file as an exercise while learning FreeCAD and 'graduating' from TinkerCAD, and uploaded an improved file June 24, 2025, this new one is very good.

I printed this on my Prusa Mini+, on its side with the retaining clips on the end facing sideways, not up. This puts the layer lines in best orientation but does require a little support. I used support on the tips of the three protruding braces and on the retaining clips at either end. The rest of the handle bridged the gaps while printing and turned out fine.