Lavalier Mic Stand (v1)

**Hello all!** This is my `Lavalier Mic Stand (v1)` design.

I am an amateur gameplay recorder. As such, I need a mic while recording videos. I made do with my headset mic for a while, but it was low quality and uncomfortable to record with. Instead of buying a new desktop microphone, I decided to use one of the many lavalier microphones I have lying around. Thus, this little stand was born!

I'm still pretty new to 3D designing. That being said, the design is simple enough to print within a few hours and sturdy enough to last a good while, in my humble opinion.

Although this is not my first original design, this is my first official upload to Thingiverse. I hope this project is as useful to someone else as it is for me. Enjoy!

**- Nate**
---
###Notes:
- The "solid" design prints significantly faster than the original cutout design.
- Hardware used: **M3 12mm hex screw**, **M3 nut**
- Zip ties allow for easy cable management.

---
##Shaft Dimensions:
- to hinge