Layens Hive Frame

A frame for a layens bee hive based on the measurements from Dr. Leo at www.horizontalhives.com.

Holes are in the top and bottom bar for wire reinforcement. No idea if these will hold up to using the melt in method of putting in beeswax foundation. My guess would be if you're really careful you should be fine since beeswax melts at a much lower temperature, but do so at your own risk.

I've only printed one set of these with the v1 side bar thus far. No idea how well they will hold up, but I think some glue and melted in screw or nail should hold these together just fine.

I was able to print all the required pieces for a frame on my Ender 5 Plus by turning the top bar on it's side, and printing everything diagonally to the bed.