Thingiverse
Layer FAn for Greg's Wade
por gforster
7
Descargas
6
Likes
0
Makes
I needed a layer fan for my Graber i3 print.
Found many models on Thingiverse but most of them were too big or munted in a position that was not good, most of the time coliding with the Z axis as by alvaroalea Feb 28, 2017 thing https://www.thingiverse.com/thing:2143701 said.
Thanks to him I could join both pieces of his device in just one.
Now there is no need for glue, but support
Found many models on Thingiverse but most of them were too big or munted in a position that was not good, most of the time coliding with the Z axis as by alvaroalea Feb 28, 2017 thing https://www.thingiverse.com/thing:2143701 said.
Thanks to him I could join both pieces of his device in just one.
Now there is no need for glue, but support
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!