LD2450-ESP32 Case

A case to house your LD2450 and an ESP32, plus a mount to put it in the corner. Everything snap fits together and the wires should hold the board to the offset pins, however they are threaded so if you want you can use M2.5 screws to screw it down. I used an inexpensive ESP32 WROOM-32 (30pin) from Aliexpress:https://www.aliexpress.com/item/1005005953505528.html?spm=a2g0o.order_list.order_list_main.10.7dd71802Eydi7X And an LD2450 unit (recommend getting the one with an antenna and cable for ease of installation):https://www.aliexpress.com/item/1005006121923099.html?spm=a2g0o.order_list.order_list_main.11.64841802Jr5eZn I use the TX0 and RX0 pins on the board. They correspond to GPIO1 and GPIO3 respectively. Make sure you reverse the TX and RX from the LD2450 and the ESP32 so the TX from one goes to the RX of the other. To find the zones you can use the app “HLKRadarTool” on your mobile phone and connect to the LD2450 via bluetooth (hence the usefulness of the antenna). This will allow y