Leader 120 Canopy

This canopy is for the fullspeed leader 120
I designed this canopy to accommodate the runcam micro Swift 2 fpv camera.
The goal here was to keep the leader look but also provide proper fit and camera protection for the Runcam.

To put this together you will need to First rem out the side plates to allow the bolt to pass through. (#31 drill or .125 drill)(the side plate screws that come with the leader will not fit) You will need to get 6 M3x8 or M3x6 screws this can be either nylon or Steel, if you do choose to go with nylon I would run a steel screw in there to help put threads in the plastic, or if you have a 3m x .05 tap, first drill out with a #40 drill before tapping
depending on your printer the holes should be pretty close to the right size

This is bolted to the frame using the original 2 screws that came with the leader
After getting the canopy bolted together I put it on the frame and used a 1/16 drill bit to drill the hole for the screw to go in.