Thingiverse
Leafy Seadragon
von Scintilla
457
Downloads
422
Likes
3
Makes
I'm back! With a dragon like I said I would.
It's a leafy seadragon! I failed horribly making one out of clay years ago, so I printed one!
I included STL files of the whole dragon and one that has been quartered up. The quartered one is actual dragon size and has a hole in its belly to stick a 1/8 inch stick in to use as part of a stand.
The one in the picture is about 16 x 10.25 x 3.25 inches total.
printed in PLA
MakerBot Replicator 2
high setting. 2 shell.
It's a leafy seadragon! I failed horribly making one out of clay years ago, so I printed one!
I included STL files of the whole dragon and one that has been quartered up. The quartered one is actual dragon size and has a hole in its belly to stick a 1/8 inch stick in to use as part of a stand.
The one in the picture is about 16 x 10.25 x 3.25 inches total.
printed in PLA
MakerBot Replicator 2
high setting. 2 shell.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
