Leather Strip Beveler

I work with leather on a regular basis, and sometimes you have a leather strip that is square or flat and need it to be round.... so I made this.

Print it at 100% infill for best results.

Moisten the leather, preferably with warm water, or neatsfoot oil. Secure the beveler with a tabletop vice for example, and thread the leather through. if you can use the big hole first, then the smaller one, that will give better results. Also, printing with more (different) sizes helps a LOT.

Dont use it if you have to pull very hard, as the leather may break off.
If the edge of the holes of the beveler degrade, replace it, or the leather strips will have ugly marks.

Good luck!


This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/eXKVeAe3h9t