Leatherman Skeletool Hammerbits Mod

Remixed the Skeletool hammer to hold 2 extra bits in the carabiner/bottle opener.Video of it in action: https://www.instagram.com/p/DELgBNCuuYD/v2 already availableextra plastic around the pin-hole & less… uhhh “glitches”? The model is smoother, fits better & more clicky, also the installed bit acts to lock the top from opening when the skeletool is closed - print standing up on the larger flat end, not the hammer end, pin hole at the bottom. It's stronger that way. Bottom part is unchanged, absolutely perfect in every way. The bottom part snaps in place like in the picture, the little curve going “down” against the handle of the Skeletool, it should firmly snap in place, no glue required. Use a li'l superglue when putting the pin in the top part & make sure the groove on the pin is rotated to allow the bit that's installed on the Skeletool to slot in place when the tool is closed - give it a good squeeze before the glue sets. If the bits are getting stuck when opening, you