LED Bar for C270 Camera Mount System

I was looking for a way to add an adjustable LED bar to the amazing Camera Mount System designed by FedorSosnin (https://www.thingiverse.com/thing:3147899). This consists of three parts: a modified version of the C270 camera mount, a completely new design for the curved light bar, and a light bar diffuser/cover. You will also need an extra nut and ring spacer from the original camera mount system. The LED light bar was designed in Tinkercad, and it is meant to hold 2 strips of six 2835 LEDs. There are 3 wire holders underneath, and a hole in the center to feed the wires to the LED strips. I wired the strips in parallel by first joining them (+ to +, - to -) with very short bare wire segments. Then I just soldered the power wires to the short segments from behind. Now I can aim the LEDs lower for shorter prints, and higher for bigger ones. There is also a fairly deep inset for the LED strips to keep the light directed ahead. I have not printed the diffuser/cover yet, but it ca