Thingiverse
LED Bottom Lit Display Base
di askronaut
16
Download
10
Likes
0
Makes
This is a LED backlit (or bottom lit) display stand for your 3D prints (I'm using this one for the glow in the dark Eiffel Tower). But It could be used for anything that'll fit on a 135mm x 135mm platform. The base could be scaled up to match your need. It may throw some of the geometry off for the screw holes and the wire pass through hole. As well as the PCB designed for this stand.
For this project, I used a black PLA for the base, and a wood filament for the outer housing. The wood filament was sanded down using 80, and then 220 grit, and then stained with a polyurethane stain from Lowe's. It only needed one coat to get my desired shade.
I used a 3mm sheet of plexiglass that was scuffed on one side to create a "frost" effect. I'm not sure if that's going to be the final piece for production. I may use the same plexiglass but pickup some frost film from Lowe's and see if that diffuses the light any better.
I've attached my gerber file if you'd like to use the PCB as well
For this project, I used a black PLA for the base, and a wood filament for the outer housing. The wood filament was sanded down using 80, and then 220 grit, and then stained with a polyurethane stain from Lowe's. It only needed one coat to get my desired shade.
I used a 3mm sheet of plexiglass that was scuffed on one side to create a "frost" effect. I'm not sure if that's going to be the final piece for production. I may use the same plexiglass but pickup some frost film from Lowe's and see if that diffuses the light any better.
I've attached my gerber file if you'd like to use the PCB as well
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
