LED Clips for Maker Select Plus

These are clips I designed and printed to hold an LED strip on the frame of my Monoprice Maker Select Plus. The LED strip plugs into a USB port of my Octoprint server, so they are on when the server is on and off when the server is powered off.

There are two different clips - one for the side frames and one for the top frame. This is because the edges are of different widths. I used a total of 7 clips for the sides (3 on the side where the Octoprint server was mounted and 4 on the opposite side) and a total of 4 clips for the top frame. These were all printed vertically, so no supports are needed.

The LED strip is one made for the back of a TV, but it works great for this application. The clips are designed for a strip that is 6.5 mm wide - anything else will likely not work. The specific strip I purchased is on Amazon ($10) at: http://a.co/hy5a0V7