Thingiverse
LED Extrusion Mount
von benvonhandorf
0
Downloads
0
Likes
0
Makes
A friend had given me some short segments of ~2020 extrusion with an angled recess for mounting LEDs in it. I made these parts to mount a segment of that to the 2020 frame of my printer.
In the samples I have, the extrusion is not QUITE the same length on both sides (~18.1mm vs ~18.6), so I took that into account in this design.
In the samples I have, the extrusion is not QUITE the same length on both sides (~18.1mm vs ~18.6), so I took that into account in this design.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
