LED fixture for Replicator, CTC, Flashforge

I designed this bracket to mount into the front corner of my CTC 3D printer using 3M double sided tape. It is designed to sit in the corner and create a 45* flat section to which a12V LED strip was attached.I wired the two LED strips in series so that my 24V power supply could run them without any sort of step-down transformer or a wall wort. I like my installs to be clean. I wired it directly to two of the screw terminals on my power supply that weren't being used and then drilled a hole in the faceplate of my printer to fit a 3/4" rocker switch.

Goodbye days of hovering over my printer with a flashlight!