Thingiverse
LED Indicator bar
von sinned6915
2
Downloads
0
Likes
0
Makes
To create indicator lights to monitor the operation of the hotend, extruder cooling fan and hot end fan when observing via remote camera. The bar mounts to the original fan fixing location.
The LED's are 3mm prewired with resistors that are tapped and soldered to the devices at the carriage. You WILL need to solder these connections and figure out the polarity of the devised to make the LED's work.
To attenuate the brightness of the LED's, the light bar is solid at the front with 2-3 layers of material to tone down the brightness.
The screw holes are pilot hole sized for the original M3 screws that mounted to the fan bracket.
The LED's are 3mm prewired with resistors that are tapped and soldered to the devices at the carriage. You WILL need to solder these connections and figure out the polarity of the devised to make the LED's work.
To attenuate the brightness of the LED's, the light bar is solid at the front with 2-3 layers of material to tone down the brightness.
The screw holes are pilot hole sized for the original M3 screws that mounted to the fan bracket.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!