Thingiverse
LED Light Clip
von Rexxenexx
6
Downloads
10
Likes
0
Makes
I had so many of these balloon LEDs, they're a dime-a-dozen on Amazon, and I REALLY needed better (hands-free) lighting when working, so I made these clips for my Milwaukee safety glasses (Milwaukee 48-73-2020, and its shaded version).
The LEDs can be found for cheap on Amazon from multiple sources. Here is one:
https://www.amazon.com/Yizhet-Balloon-Multicolor-Christmas-Birthday/dp/B0BKRXGMX6
LED Specs are in the photos section, although my measurements are 12.84mm x 30mm exactly, anything looking like the photos will be the correct one, like every other Amazon spammed product ;)
I recommend cutting off the little loop in the back so the switch is easier to toggle without looking. The seam is what grips the clip well, so make sure your switch is vertical. Click up, ON. Click down, Off. Slide it back to front of glasses and it'll be solid.
You can also Mirror it in your slicer so you can have TWO LED lights on your safety glasses! Works great.
No supports needed. Brim re
The LEDs can be found for cheap on Amazon from multiple sources. Here is one:
https://www.amazon.com/Yizhet-Balloon-Multicolor-Christmas-Birthday/dp/B0BKRXGMX6
LED Specs are in the photos section, although my measurements are 12.84mm x 30mm exactly, anything looking like the photos will be the correct one, like every other Amazon spammed product ;)
I recommend cutting off the little loop in the back so the switch is easier to toggle without looking. The seam is what grips the clip well, so make sure your switch is vertical. Click up, ON. Click down, Off. Slide it back to front of glasses and it'll be solid.
You can also Mirror it in your slicer so you can have TWO LED lights on your safety glasses! Works great.
No supports needed. Brim re
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
