Led Light System For Prusa Frames

I was working off of spradlinb's led light bar. He uses a 14mm diameter for the bar, which I keep the same here. However, my led lights are much thicker (9.5mm) so I had to increase the area to hold the strip to 10mm. I also deepened it to 3mm so as to help shield and focus the light downwards. Finally, 6 lights measured 200mm, so I only have the light bar be that long (you can easily scale the bar to adjust this).

For the bracket, I did not need something so sturdy. Spra's bracket could hold at least a pound, if not more. This bracket can hold the light bar and so it saves a good bit of material. I also adjusted the bracket to be an extreme cantilever so that the bracket can be completely on one side of the frame -- leaving more room for spool holders or other attachments.

I hope will enjoy this system! I have attached the step file so you can make minor adjustments easily.