Thingiverse
LED Mount
by TobiasBrage
20
Downloads
19
Likes
0
Makes
This is a LED Mount/Clip i made for adding light to my car door but can be use for anything! Print with transparent/nature filament for best results.
It fits an 5mm LED but you may need to hot glue the LED just to be sure it stays in place.
Drill an hole by 10mm and click it in!
Adjust the model yourself depending on how thick the material is, the standard of this model is 4mm.
-- Watch the images to see what i used these for, i've added two of them at each door, one red pointing backwards and one white pointing down, they only light up when opening the doors since i hooked them up with the same wires from the Interior lights. --
It fits an 5mm LED but you may need to hot glue the LED just to be sure it stays in place.
Drill an hole by 10mm and click it in!
Adjust the model yourself depending on how thick the material is, the standard of this model is 4mm.
-- Watch the images to see what i used these for, i've added two of them at each door, one red pointing backwards and one white pointing down, they only light up when opening the doors since i hooked them up with the same wires from the Interior lights. --
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
