Thingiverse
LED Night Lamp
by Sophiesus
3
Downloads
14
Likes
0
Makes
Designed with Fusion360 to make my night Lamp.
Used 3W LED Cornlamp with E14 Base, E14 Base socket, Cable having switch and diffuser Sheet.
After printing, Lamp without diffuser sheet has limited area of light.
Diffuser sheet attached, it gave out more light beautifully.
It's a bit redundant to attach flat diffuser sheet on curve shaped Lampshade.
It's necessary to cut the diffuser sheet to fit curved surface.
You can refer to the following Youtube.
P.S : Tolerance for assembly
Tolerance can be a bit tight.
If necessary, you can make a bigger tolerance.
Between Lampholder and Lampshade => 0.15mm offset, total 0.3mm
Between Lampholder and Body => 0.1mm offset, total 0.2mm
Between Body and cover => 0.05mm offset, total 0.1mm
Used 3W LED Cornlamp with E14 Base, E14 Base socket, Cable having switch and diffuser Sheet.
After printing, Lamp without diffuser sheet has limited area of light.
Diffuser sheet attached, it gave out more light beautifully.
It's a bit redundant to attach flat diffuser sheet on curve shaped Lampshade.
It's necessary to cut the diffuser sheet to fit curved surface.
You can refer to the following Youtube.
P.S : Tolerance for assembly
Tolerance can be a bit tight.
If necessary, you can make a bigger tolerance.
Between Lampholder and Lampshade => 0.15mm offset, total 0.3mm
Between Lampholder and Body => 0.1mm offset, total 0.2mm
Between Body and cover => 0.05mm offset, total 0.1mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!